Before starting, make sure your laptop is fully powered off and unplugged from any power source. Use the right tools—typically a screwdriver set included in the package—and work on a non-conductive surface to prevent static electricity damage.
This tutorial will guide you in detail how to remove the Apple A1820 / Macbook Pro 15" Retina A1707 Touch Bar battery. You can watch the tutorial video below.
Step 1
Remove the rear case screws one by one.
Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from to avoid damaging your device.
Step 2
Take a suction cup and use it to suck up a gap.
Step 3
Use a plastic sheet to gently slide along the edge.
Step 4
Disconnect the battery connector from the logic board.
Step 5
First tear off the battery reminder paper.
Step 6
Unscrew the three screws on the battery
Step 7
- Remove the screws securing the motherboard.
- Unhook the various connection cables on the motherboard.
Pay attention to the position, size and length of the screws.
Step 8
Removing the Motherboard.
Step 9
Use a plastic shovel to remove the double-sided tape at the bottom of the battery.
Step 10
When shoveling this battery, do not press down hard.
Step 11
After removing all the double-sided tape sticking to the bottom of the battery, remove the battery.
Step 12
Align the new battery and motherboard and put them back in place.
Step 13
Buckle back various cables and fix the motherboard screws.
Step 14
Install the three screws that secure the battery connector.
Step 15
Power on and test all functions to be normal.
Step 16
Align the position and push forward from the touchpad direction.
Step 17
Pay attention to the screw position and length, and tighten the screws.